Window contact switch radio system, white, with external antennae
Product number:
7051001
- Window contact switch
- installation in extractor hood (motor cable)
Description
Window contact switch radio system, white, with external antennae
The COMPAIR® window contact switch radio system is a clever all-in-one solution for targeted management of extract air control. It is used if, in addition to the extractor bonnet, room air-dependent fireplaces such as a stove or a fireplace are also present. The installation of the radio extract air control or a wired control is required by law under the conditions mentioned. Negative pressure in the room is avoided, where dangerous gases can form without a supply of fresh air from outside. The set includes a safety switch via which the cooker bonnet is connected to the mains. In addition, there are two contact switches with wireless radio transmission, which are attached to the window frame and the window sash. If one of the fireplaces is in operation, the extractor bonnet can only be switched on if the window is detected as open. The contact switch is equipped with an external antenna to ensure secure transmission of information. This applies, for example, when using a stainless steel chimney cowl, as this weakens the signal. The antenna is attached to the wall or ceiling next to the cladding.
Safety switch with wireless radio transmission via an external antennae for application under difficult reception circumstances, such as installation behind stainless steel casing. Ready to plug with transmitter and receiver, including installation material and batteries (long life, low energy consumption).
— switching capacity up to 1150 W (5 A)
Safety switch with wireless radio transmission via an external antennae for application under difficult reception circumstances, such as installation behind stainless steel casing. Ready to plug with transmitter and receiver, including installation material and batteries (long life, low energy consumption).
— switching capacity up to 1150 W (5 A)
Article type:
Window contact switch
Certification:
TÜV
Colour:
white
Connectivity:
radio
Current:
5 A
Discontinued item:
No
Form:
angular
Further:
battery monitoring, radio range monitoring, relay contact 5 A N/O contact (potential-free)
Incl. mounting material:
incl. mounting material
Mounting/Fixing:
installation in extractor hood (motor cable)
Note:
Safety switch with wireless radio transmission via an external antennae for application under difficult reception circumstances, such as installation behind stainless steel casing
Power:
switching capacity up to 1150 W (5 A)
Downloads
Contact persons and kitchen professionals in your area
The nearest Naber dealer is not far away. On this page you will find competent contact persons and kitchen professionals.
There are three print catalogues: BASICS, TECH and INTERIEUR. They are a popular orientation guide and a rich source of information for browsing and looking around. Let yourself be inspired!