Slash switch, stainless steel
Touch-free operation: the stainless steel-coloured Slash IR sensor switch. Its unobtrusive design is visually convincing, so that it can be harmoniously integrated into the kitchen architecture in a suitable place. It works in combination with LED converters and low-voltage transformers with flat plugs to provide a special lighting atmosphere and good illumination in the kitchen. The motion switch is recommended for all surface-mounted and recessed luminaires in the Slash series because it is perfectly matched to the technical requirements. It is connected via a connecting cable with a mains plug and a supply cable including a Euro flat coupling. Thanks to its length, the sensor cable leaves enough room to place the infrared switch at the desired position within the kitchen unit.

Non-contact switch.
— for all LED converters and low-voltage transformers
— special recommendation for all Slash lights
— 2000 mm mains connecting line with flat European plug
— 500 mm supply line with flat European coupling
— 2000 mm sensor cable

Article type:
Stainless steel
29 mm
Length of connection cable (secondary):
2.000 mm
Length of the supply line (primary):
500 mm
stainless steel
surface mounting
Sensor cable length:
2.000 mm
35 mm

Contact persons and kitchen professionals in your area

The nearest Naber dealer is not far away. On this page you will find competent contact persons and kitchen professionals.


There are three print catalogues: BASICS, TECH and INTERIEUR. They are a popular orientation guide and a rich source of information for browsing and looking around. Let yourself be inspired!

Catalogue PDFs Online catalogue