Kickspace KS 500
Product number:
6011001
- Base heating system
Description
Kickspace KS 500
The Kickspace KS 500 baseboard heater is a creative and, above all, space-saving heating solution for the kitchen or other rooms. Compared to a conventional radiator, it does not take up any space in the room and is instead simply installed in the plinth space of the base unit. In terms of heating output, it is in no way inferior to a radiator and can also be connected to the central heating system of the building. The KS 500 is suitable for fast and effective heating of rooms up to 12 m² in size. The Kickspace compact heater has two individually selectable power levels in heating mode and a cooling air circulation for summer. Thanks to the powerful convector technology in the smallest possible space, the energy-efficient baseboard heater only needs about half the heating time compared to regular heaters. What's more, thanks to the whisper-quiet fan technology, its operation is barely noticeable. The heating output of the unit depends on the flow temperature and flow rate of the heating system, and for proper operation, the average flow temperature must not be below 60°C. The installation of Kickspace is quick and uncomplicated: With a few simple steps, the heating module can be securely installed in the plinth space and connected to the central heating system. The stainless steel-coloured outer cover is also available in the Naber Shop. A room thermostat for easy regulation of the room temperature is also available in addition to the required connection material.
The compact base-installed heating system for rooms up to about 12 m² can be connected to the central heating system with little effort.
— connected load 230 V/50 Hz
— heating system exclusively for 2-pipe system
— minimum base height 125 mm
Cover plates need to be ordered separately.
PLEASE OBSERVE:
For proper operation, the average feed temperature should not fall below 60 °C.
The heat output of the device depends on the feed temperature and the flow rate of the heating system.
The compact base-installed heating system for rooms up to about 12 m² can be connected to the central heating system with little effort.
— connected load 230 V/50 Hz
— heating system exclusively for 2-pipe system
— minimum base height 125 mm
Cover plates need to be ordered separately.
PLEASE OBSERVE:
For proper operation, the average feed temperature should not fall below 60 °C.
The heat output of the device depends on the feed temperature and the flow rate of the heating system.
Article type:
Base heating system
Colour:
stainless-steel coloured
Connection to central heating system:
Yes
Depth:
309 mm
Engine power:
25 W
For room size:
12 m²
Heating capacity:
740 - 976 W
Heating medium:
water
Height:
93 mm
Mains frequency:
50 Hz
Mains voltage:
230 V
Minimum plinth height:
125 mm
Note:
Cover plates need to be ordered separately., For proper operation, the average feed temperature should not fall below 60 °C., The heat output of the device depends on the feed temperature and the flow rate of the heating system.
Plug type:
Angle plug
Standards:
the noise levels were tested according to EN 23741.
Suitable pipe system:
2-pipe
Switch:
Yes
Width:
322 mm
Downloads
Contact persons and kitchen professionals in your area
The nearest Naber dealer is not far away. On this page you will find competent contact persons and kitchen professionals.
There are three print catalogues: BASICS, TECH and INTERIEUR. They are a popular orientation guide and a rich source of information for browsing and looking around. Let yourself be inspired!