HTB bend, angle 45°, Ø 50 mm
Product number:
1053017
- Drain pipe
- Material: polypropylene
Description
HTB bend, angle 45°, Ø 50 mm
The HTB bend is used when a deflection is required within the wastewater installation. It is available in graduated versions with an angle of 15° up to 87.5°. The heat-resistant bend is made of polypropylene in accordance with the DIN 4102 standard.
Standardised bend piece made of PP per DIN 4102.
Standardised bend piece made of PP per DIN 4102.
Article type:
Drain pipe
Colour:
grey
Diameter/nominal width (DN):
Ø 50 mm
Elbow hose fitting:
45°
Material:
polypropylene
Accessories
MAGAZINE
Little things make big differences
With the MONTEC® range, Naber supplies all the relevant standard components – from the set for the sink connection to the kitchen connection box, which considerably simplifies the electrical installation of multiple large appliances.
Contact persons and kitchen professionals in your area
The nearest Naber dealer is not far away. On this page you will find competent contact persons and kitchen professionals.
There are three print catalogues: BASICS, TECH and INTERIEUR. They are a popular orientation guide and a rich source of information for browsing and looking around. Let yourself be inspired!